Prepare Your Surface
Before you begin, proper wall preparation is essential for a smooth finish. Start by cleaning the wall with a mild, non-oily cleaner to remove any dust or grime. For best results, the surface should be as smooth as possible. Repair any holes or cracks with spackle, and then sand the patches until they are level with the wall. A clean, smooth surface ensures that the easy to apply wallpaper will adhere correctly and last longer.
Measure and Cut Your Wallpaper
Measure the height of your wall and add a few extra inches to your measurement before cutting the first panel of wallpaper. This extra length provides a margin for error. As you cut subsequent panels, hold them up to the wall to align the pattern with the previously applied sheet before cutting. This step is crucial for achieving a seamless and professional look. Many renter-friendly wallpapers come with grid lines on the back to guide your cuts.
Begin the Application
Start applying the wallpaper from a top corner of the wall. Peel back the first few inches of the backing paper and press the adhesive side firmly against the wall. Use a smoothing tool or a plastic card to press the paper to the surface, working from the centre outwards to push out any air bubbles. Continue to pull the backing away slowly as you smooth the wallpaper down the wall. This methodical approach is key for handling peel-and-stick removable wallpaper.
Address Tricky Areas
When you encounter corners or outlets, careful trimming is necessary. For outlets, turn off the power, remove the cover, and apply the wallpaper over the opening. Then, use a utility knife to carefully cut away the paper covering the outlet box and screw the cover back on. For corners, press the paper firmly into the crease before trimming any excess. If you have a textured surface, the process requires special attention; you can find more details on applying wallpaper on textured walls.
Consider Creative Options
Your options are not limited to single patterns. For a more dramatic effect, consider using wallpaper murals peel and stick. These large-scale designs can create a stunning focal point in any room. The application process is similar to standard renter-friendly wallpapers but requires careful alignment of the multiple panels that make up the mural.
Ensure a Smooth Finish
As you apply each panel, overlap it slightly with the previous one to ensure there are no gaps. Once a panel is fully applied, run your smoothing tool over the entire surface one more time to secure the adhesion and work out any remaining air bubbles. If a stubborn bubble appears, you can prick it with a fine pin and then press the air out. This helps maintain the sleek look of your wallpaper for renters.
The Removal Process
When it is time for a change, the removal process is straightforward. Because this is an easy-to-remove wallpaper, you can simply start at a corner and gently peel the panel away from the wall. A major benefit of temporary wallpaper is that it leaves no sticky residue or damage behind. If you have any further queries, you may find a Question Answer on Renter-Friendly Wallpaper section helpful.
Comments
0 comment